Maytag Repair Waterloo

Function Key Stuck: replace touchpad or if the touchpad is part of the clock, replace the clock. 

Defective Touchpad or Clock (ERC): replace touchpad or clock. The touchpad is the most common reason to trigger this error code.

Oven Temperature Too Hot: check sensor harness to make sure it is not broken or damaged. If not, replace the relay board or oven temperature sensor. 

Shorted or Open Oven Temperature Sensor: check the sensor harness and harness connections between oven sensor and oven control. Replace oven temperature sensor if the wiring is not damaged.

Watchdog and Hardware Conflict: Replace clock (ERC)

Function Key Stuck or Shorted: Replace touchpad or clock if the touchpad is part of the clock. 

Analog/Digital Problem: Replace clock (ERC)

Door Latch: Check door latch components and replace if damaged or broken.

Control Lock Engaged: the control lock is active on the washing machine. To turn this off touch or hold the Control Lock button. 

Detergent Cartridge Not Detected: this is only on select models that have a detergent cartridge. If you are using single-use load doses, ignore this code.

Cycle Paused or Cancelled: the washer will take between 20 to 30 minutes to spin and drain the water, this code will appear until this is completed. 

Items Detected During Clean Washer Cycle: if you are performing a clean washer cycle and there are items in the drum, this code will appear. 

Door is Not Locking Properly: check to make sure nothing is blocking the door from locking or closing completely. To clear this, press the Pause or Cancel button twice and the Power button once. 

Motor Speed Sensing Error: this indicates that there is a problem with the motor achieving the proper speed for the cycle selected. Check that all shipping bolts are removed and the washer is not overloaded. To clear this, press the Pause or Cancel button twice and the Power button once. 

Washer Flow Low: this indicates that there is a low flow of water into the washer. Check that the inlet valves are open and that the flow hoses are not kinked. 

Dispenser System Error: this indicates that there is an error with the detergent drawer or the detergent cartridge, check to make sure there is no clog.

Long Drain Times: when this code appears it means that the washer is draining slower than normal. Check to make sure there is no kink or clog in the drain hose. If this is not the cause, excess suds from too much detergent can cause the washer to drain slower than normal.