Frigidaire Repair Cambridge

Freezer or Fresh Food Sensor Error: This error code indicates there is either an error with your fridge or freezer, dependent on what side you see this code displayed under. This error means there is an issue with the thermistor. Check the wiring for any loose or disconnected wires and replace them as necessary. If no issues are found with the wiring, it is likely a faulty thermistor.

Evaporator Fan Circuit Error: This error code indicates that the evaporator fan is not working and you will be able to tell if this is the case if your fridge is not staying cold.

For this error: check the wiring, control board, and evaporator fan. 

Failure with Communication from Main Control Board: This error indicates that the user interface is unable to communicate with the main control board. 

For this error: there may be a damaged, loose, or faulty wire, a faulty display panel, or a faulty control board.

Defrost Circuit Error: This error indicates the fridge is unable to perform a defrost cycle. This cycle is important as it must be performed to be able to ensure no critical components ice over.

Refrigerator in Sabbath Mode

Heat Delay (Water Temperature Low): Water temperature must rise before wash cycle can begin.

Low Rinse Aid: Aid dispenser is low and must be filled.

Power Failure: This usually occurs during a power outage. To reset it, open and close the dishwasher door.

Drain Line Restricted: Water line supply is kinked or clogged.

Leaking Bottom Pan: Check for any loose connections with the hoses and ensure the unit is level.

Wash or Drain Motor Failure: Motor failure, to see if this is accurate, press and hold the cancel button or turn off the power at the breaker. If this does not clear the code, it is either a faulty drain motor or a loose wire.

Water Heating System Failure: Water is unable to heat to temperature to run. To try to clear this code, turn off the power or press and hold the cancel button. If this does not clear it, check the wiring between the heating system and the control board. If no issues are found with the wiring, replace the water heater or control board.

Electronic Control System Failure

Vent Open

Vent Failure (Fan is Not Running)

Membrane Switch Failure/Stuck Key: A switch inside the dishwasher is stuck.

Configuration Error: Check the wiring between the keypad and the control board. Fix any damaged or loose connections. If no damage, replace the main control board.

Close Door (Door Switch is Open): Check to see if the door switches are damaged and replace them. If no damage, check the wiring between the door switches and the main control board. Replace the main control board if no issues are found with the wiring or door switch.

Drain Pump: This code appears during a relay test and when the drain pumped is activated.

Water Valve Open: This code appears during a relay test when the water valve is activated.

Hall Sensor Error: Check to wire between the motor and the control board. Replace the control board if no issues are found with the wiring.

Rinse Aid Reed Switch Error: First, fill in the rinse aid to see if this clears the code. If it is still appearing, check all wiring between the main control board and the dispenser. Replace the dispenser if no issues are found with the wiring.

Rinse Aid Reed Switch: Rinse aid switch is closed.

Rinse Aid Reed Switch: Rinse aid switch is open. 

Relay/Triac Test: Dishwasher in relay test mode.

Detergent Dispenser: During a relay test, this code appears when the detergent dispenser is activated.

Turbidity Sensor Failure